ThermaPlex® Hi-Temp Bearing Grease

The silicone-rich, water-based formula that protects rubber and plastic parts. FEATURES Water-based, silicone rich formula that lubricates and protects rubber,

SAFETY DATA SHEET 1. Identification Product identifier LPS® TKX (Aerosol) Other means of identification Part Number 02016 Recommended use An industrial lubricant designed to displace moisture from equipment, provide heavy-duty lubrication and rust prevention. Recommended restrictions None known. Manufacturer/Importer/Supplier/Distributor information Manufacturer Manufacturer Company name LPS Laboratories, a division of Illinois Tool Works, Inc. Address 4647 Hugh Howell Rd. Tucker, GA 30084 Country (U.S.A.) Tel: +1 770-243-8800 In Case of Emergency 1-800-424-9300 (inside U.S.) +001 703-527-3887 (outside U.S.) Website www.lpslabs.com E-mail sds@lpslabs.com 2. Hazard(s) identification Physical hazards Flammable aerosols Category 1 Gases under pressure Compressed gas Health hazards Skin corrosion/irritation Category 2 Serious eye damage/eye irritation Category 2A Specific target organ toxicity, single exposure Category 3 narcotic effects Environmental hazards Not classified. OSHA defined hazards Not classified. Label elements Signal word Danger Hazard statement Extremely flammable aerosol. Contains gas under pressure; may explode if heated. Causes skin irritation. Causes serious eye irritation. May cause drowsiness or dizziness. Precautionary statement Prevention Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Do not spray on an open flame or other ignition source. Pressurized container: Do not pierce or burn, even after use. Avoid breathing gas. Wash thoroughly after handling. Use only outdoors or in a well-ventilated area. Wear protective gloves. Wear eye/face protection. Response If on skin: Wash with plenty of water. Specific treatment (see this label). If skin irritation occurs: Get medical advice/attention. Take off contaminated clothing and wash before reuse. If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention. If inhaled: Remove person to fresh air and keep comfortable for breathing. Call a poison center/doctor if you feel unwell. Storage Store in a well-ventilated place. Keep container tightly closed. Store locked up. Protect from sunlight. Do not expose to temperatures exceeding 50°C/122°F. Disposal Dispose of contents/container in accordance with local/regional/national/international regulations

LPS Micro X

The moly-fortified lubricant that performs under severe loads and extreme temperatures FEATURES Fortified with molybdenum disulfide Increases chain and wire